Peyote's 3D Printed Dash Updates
Got it in and flush, I decided to cut part of the bottom of the dash rather than the top, so the mounting tabs don't line up. Other tweaks needing to be done are:
Angle the top edge of the curve back and up to close the gap to the dash cap
Lower the steering wheel cut out so it covers more of the dash frame there
Overall bottom edge extend downward by 1/2"
That's about it! Now I just need some time to make the changes and the money to send it off
Got it in and flush, I decided to cut part of the bottom of the dash rather than the top, so the mounting tabs don't line up. Other tweaks needing to be done are:
Angle the top edge of the curve back and up to close the gap to the dash cap
Lower the steering wheel cut out so it covers more of the dash frame there
Overall bottom edge extend downward by 1/2"
That's about it! Now I just need some time to make the changes and the money to send it off
