slant 6 rebuild and upgrade list

I'm getting ready to redo my engine now that I have the body of the car close to being done. I am still looking for a decent machine shop near the Brooksville,Bushnell, Ocala area in Florida.

Here is my basic list. I am open to suggestions about products and services


Slant 6 upgrades for eventual turbo.
9.1 approximate compression for pump gas. So no 10+ compression ratio I am not racing it just want it to be a bit smarter on acceleration and drivability.
Head
I have a Peanut head that I will be using (not drool tube, but I do have the original Drool tube 66 head if that would be better).
1. Need to hot tank and check for cracks.
2. Remove studs in head (save for cleaning and repair/replacement)
3. Valve replacement and repair
4. going to 1.70 And 1.44 for a little better flow.
5. Hardened exhaust seats
6. New guides / springs
7. Surfaced for flatness
8. find Sanden A/C mount for /6(nope not going to give up my A/C)
9.
10.

Block (5 Welch plug engine)
Unknown year and I'm looking for numbers on the block, 67-72 square A body 4 door donor (well at least the firewall, flat not beaked hood and one fender was).

11. Hot tank block
12. Rings, rods, cam bearings and main bearings (bore if needed)
13. Check crank and repair (/undersize as needed).
14. Deck the block .060-.080 to get the pistons closer to the deck. (.185 down now)
15. I will order new cam and lifters from Oregon Cam to get correct cam for the project.
(Looking at a slight upgrade from stock but the same or less overlap to help turbo, but open for suggestions since I'd like a nice idle for the A/C).
16. Order new pushrods after final measurements taken
17. New timing chain set. Mellings or Roll master set.
18. Get slant six 1966 oil pan and oil pickup tube off of trashed engine.


Add-ons or missed ideas (To Be Determined)
30. using "waggins" dual exhaust manifolds to route exhaust where I want it to go.
31.
32.
ect.