vacuum gauge to solve idle issue

Thanks Dar. Got it fired up and out for rip today. I adjusted the choke by dialing the black choke housing. I verified voltage (10.5 V) to red power wire.
Idle screws out 1 1/2 turns initially then adjusted with rpm/tach. I could hear a rpm change when fine tuning drivers side but not so much with pass side.
I thinks its close but I stopped for gas and it seemed flooded once I was done fueling up? Not too hard a start tho.
Tomorrow I'll see how it acts from a cold start
In my pic from the manual you see they show different linkage rods for adjustments, not the top linkage??