Mopars with BIG DADDY DON GARLITS 2016...get ready, Guys!!
With all the goodies you sell on FABO, I'm sure your Panel is probably pretty NICE...but: IF it is badly creased on the rims, sometimes I cant fix them. The determining factor to resto on these Panels is if the Textured area is straight. It is really tuff to get pressure dings out of this area. Look at it at an angle, if the textured area is straight then it's a good Candidate. If it is rippled, I cannot get all of it out. +++++++ ALSO, you must purchase the repro Center pieces for your Taillights and bring them with you for paint match. These tie into the Rear Finish Panel on the 67s. Everybody forgets to do this when they get their Panels done. But you can send them to me at a later date and I will paint match them then FOR FREE.
REAR UPPER & LOWER TRIM. They are reproducing these pieces now, as you probably know. The top piece is useable, but they send you 2 top pieces and expect you to use the top on the bottom...but it does not fit. Be on the lookout for an OEM piece for the bottom. Dont modify the top piece to fit the bottom, you'll only ruin your paint and it still wont work. They come up quite often on FABO, so keep searching.
EMBLEM: All the Cuda rear Emblems have pitting problems, probably due to exhaust. If you have some spare Panels, take a long hard look at the Emblems. Betcha one of your spares may have a nicer Emblem than your current one. The pits really are more noticeable once the piece is redone, so snag me the best Emblem you have or even better bring the spare and let me remove it.
300 + 22 shipping.
With all the goodies you sell on FABO, I'm sure your Panel is probably pretty NICE...but: IF it is badly creased on the rims, sometimes I cant fix them. The determining factor to resto on these Panels is if the Textured area is straight. It is really tuff to get pressure dings out of this area. Look at it at an angle, if the textured area is straight then it's a good Candidate. If it is rippled, I cannot get all of it out. +++++++ ALSO, you must purchase the repro Center pieces for your Taillights and bring them with you for paint match. These tie into the Rear Finish Panel on the 67s. Everybody forgets to do this when they get their Panels done. But you can send them to me at a later date and I will paint match them then FOR FREE.
REAR UPPER & LOWER TRIM. They are reproducing these pieces now, as you probably know. The top piece is useable, but they send you 2 top pieces and expect you to use the top on the bottom...but it does not fit. Be on the lookout for an OEM piece for the bottom. Dont modify the top piece to fit the bottom, you'll only ruin your paint and it still wont work. They come up quite often on FABO, so keep searching.
EMBLEM: All the Cuda rear Emblems have pitting problems, probably due to exhaust. If you have some spare Panels, take a long hard look at the Emblems. Betcha one of your spares may have a nicer Emblem than your current one. The pits really are more noticeable once the piece is redone, so snag me the best Emblem you have or even better bring the spare and let me remove it.