Jeep 4.0 in 69 Barracuda

BTW:
Does anyone have a early A Body (preferably a late 60s barracuda) in the air with knuckles off??? (and if possible using the 70s suspension)

I would like some measurements of the factory lower ball joint locations under load if possible

Measurement I am looking for (all lower ball joint)
Center Left to Right Ball Joint
Center Left or Right Ball Joint to Center Rear Left or Right Axle shaft (or Leaf Spring center pin)

My OEM setup is really warn out. I will grab numbers from it and post to this page as well. But again, they may not be as accurate due to warn parts. And it is the earlier set up with the smaller parts.