Help - Anybody have a reference pic ?

-
Ruby

Ruby

1964 Canadian Valiant Signet Convertible
Joined
Oct 4, 2012
Messages
20
Reaction score
5
Location
Ontario
Hi Guys, can anyone help with a reference pic for a 64 Dart/Canadian Valiant, I need to see what this Ebrake bracket looks like before it broke off the underside of my car, it is circled in blue, thanks for your help in advance

IMG_8283.JPG
 
i dont know for sure, but dollars to donuts it would look the same as the one to the right of it, which is NOT broken
 
Assuming a Canadian Dart is similar to a US Dart...here are pics of the two brackets under my '64 Dart Wagon (matches what diymirage said) - HTH

IMG_5600.jpeg


IMG_5601.jpeg


IMG_5602.jpeg
 
StrokerMcG said:
That sure is a clean floorpan. Media blasted or dipped?
Stroker
Click to expand...

It was media blasted and epoxy primed, its on the rotiserre getting what it deserves, your car looks great, I'm thinking of going white or silver on red..
 
If your running frame connectors and it looks like it in the pictures, I think you will find you will want to convert the park brake cable set up to the 1967 and up single style to help clear the frame connectors.
 
Great tip, I will look into it, thanks
 
Gold66cuda, do you have any information on the 67 up brake cable setup. I would be interested in seeing it. I need something different for my 66 Dart that I put frame connectors on.
Thanks Rod
 
rod7515 said:
Gold66cuda, do you have any information on the 67 up brake cable setup. I would be interested in seeing it. I need something different for my 66 Dart that I put frame connectors on.
Thanks Rod
Click to expand...
Hi Rod, I basically used the later set up front to back. I think i ordered a 68 primary cable, cable from park brake handle to spliter at back, and ran the 68 rear cables from the spliter to the rear brakes.
IMG_6944.JPG
IMG_6945.JPG
I drilled a hole on an angle at the front of the frame connector to run the primary cable through, I welded a cable guide on the back of the frame connector and added the spliter after that. Works great and passed inspection.
 
Gold66cuda, Thanks for the information. I should be able to make that work. Im not only fighting the frame rail connectors but also a 3" exhaust system! Thanks Again
Rod
 
rod7515 said:
Gold66cuda, Thanks for the information. I should be able to make that work. Im not only fighting the frame rail connectors but also a 3" exhaust system! Thanks Again
Rod
Click to expand...
No problem, glad to help. I have 2 1/2"exhaust and it clears no problem. You will have to notch your trans cross member on the right side to gain ground clearance for your exhaust.
 
Exhaust is already done and I did have to notch the trans cross member.
Thanks again
Rod
 
You must log in or register to reply here.
-

Back
Top