Finally, my first 360 and goals for it! I'll be asking a lot of questions.
Started taking it apart today and measured valves and bore. It's all stock. These pistons are stock right? I cant really feel any ridge. Dont know if Im checking right though. Should my nail get stuck there if there was a ridge?
Stock valve sizes
It looks really nice and clean, I suspect a previous owner has had it apart not that long ago.
Can you tell by the picture if it's stock or if it has been some porting done?
Springs look stock too right?
Top dead center
I did not get further today. Is there a way to measure if the heads have been milled? So it looks to be a mostly stock engine. Maybe a bit of cam and the LD340 intake. I'm thinking of having the heads milled and ported and then reuse the solid cam and valve train with adjustable rockers from my 273. Say I ever wanted to go with a hydralic cam, could I use the same valvetrain for that?