Comp valve keepers- Is this an issue??

Just talked my dad. Apparently, the part numbers all match as they should. I asked him to hold up one lock to the valve stem to see if it was tight, and he said it was tight to the stem, so the sizing was correct; they are made for 3/8" stems.

Since it seems they're tight to the stem, he says they're just a little short "side-to-side", if that makes sense; the gap between the two locks is a lot larger than the stockers. I'm going to call Comp, on Monday, when they are open to see what they have to say about it. At this point, I'm inclined to tell him to run the stock intake valve keepers, since they seem tighter.

Further, I asked him how the exhaust valve locks look. He said they are a lot tighter against each other, and even touch. I didn't think valve keepers were supposed to touch... What's with after market parts these days???