convertible top(in the well) hold down latch 63-66
Here are a few fotos of the protypes we fabricated which seem to be working out well. One of these days I will remove them, clean them up, paint 'em, and make them look pretty. For now, they get the job done. The lower spring steel portion with slotted screw holes was salvaged from the original factory pieces. The very top portion (that one would pull over to lower the top) is made from a chain link cut in half. The hook part that latches on to the top frame to hold it down, may be a little too wide and need some trimming.
Here are a few fotos of the protypes we fabricated which seem to be working out well. One of these days I will remove them, clean them up, paint 'em, and make them look pretty. For now, they get the job done. The lower spring steel portion with slotted screw holes was salvaged from the original factory pieces. The very top portion (that one would pull over to lower the top) is made from a chain link cut in half. The hook part that latches on to the top frame to hold it down, may be a little too wide and need some trimming.