Lower control arm issue

From the pictures that you posted here as well as on the FABO site. It looks as though the pivot shaft is not completely seated. To start when using the lower control arm bushing in POLY you will need to re-use your inner and outer sleeves from your control arm bushings. In many case when you press our the old bushing and pivot shaft the outer sleeve will stay in the control arm. You may need clean out any residual rubber using a heat gun and wire brush. once that is cleaned out you can install the new poly bushing. Then you will need to install your pivot shaft. Now I do see that you purchased new pivot shafts and when using the poly bushing you will need to reuse the inner sleeve. Now in the front end kit. There should have been two rubber lower control arm bushing supplied. We supply those for that purpose. Meaning to sacrifice for their sleeve. Or in some case customers like to use the rubber ones for the lower control arms. Once you have the sleeve installed on the new pivot shaft then use the polylube supplied and grease the shaft and press it into the lower control arm. All of this will be a press fit.

I would disassemble and look for obstructions to start. Please lest me know how you make out.

Thanks
James From
PST Marketing
1-800-247-2288