1967 Barracuda Formula S 383 daily driver build

Spent the morning getting all the fluids put in the car & the battery charged up.

Pushed the car out of the garage because I figure the open headers will be too loud & running it for 20 minutes to break in the cam may stink up the house.

View attachment 1715019827

View attachment 1715019828

View attachment 1715019829


Got the cam broke in but it's leaking badly out the rear of the engine. I will be pulling it out tomorrow to try & see where the oil is coming from.

Lost about 2 quarts over running it for 20 min during break in. It had ran a while when I noticed it & I kept the rpm cycling 1800-2500 to but shut it off right around 10 minutes in to check/add oil. It was a quart low & I added 2 quarts to get it thru the cam break in period.

So it ran for 10 minutes at the high break in rpm, shut it off for 3 minutes to add oil & ran for another 10 minutes at the high break in rpm, shut it off 5 for minutes to add oil, ran a couple more minutes to set timing & idle speed.

It sounded good & idled nice after setting the timing. Hopefully shutting it off mid way thru was ok, I figure it's better than running it out of oil.


daaayuum. that`s a bad leak!--enjoyed your post, "real world!" I`m just outside Collinsville, hope to meet u sometime. I don`t have many mopar friends anymore, mostly chevy buddies (racers). P M sent-----bob