Body help/advice needed

I did mostly overlapping metal. Used a air flange tool. Worked nice. The few places I did butt weld, I think it worked nicer with a small gap (maybe 1/16) as long as you back it up while welding. I was able to do a few spots without backer, but frequently shot the wire through the gap and had to cut it off the back. Plus the main reason I did but weld was if I needed the back clean, but then had to use sand disk both sides to get it right. I also have some panel clamps for butt weld setup if you want to try them. They force you to leave more gap than I wanted though so did not use them. Strong magnets work nice for small patches till you get a few tack welds. Then just stitch around till its closed.
You have it at the house now? I could stop by... Going away Sat afternoon. What time you think you will get at it Sat?
FYI - Duster is road legal now (aligned and inspected yesterday), but having issues. I think trans. Maybe kickdown? Doesn't want to go more than 25mph...