What seats are you running?

I had ordered something like that for my 68. Corbeaus they were called. By the time I got them mounted on tracks they were too high; my head was nearly into the headliner. I am only 69 inches tall. It was also too hard to get into the rear seat on the drivers side. And nobody in the back seat could hardly see out the front.I also did not like the hard seat-bolsters on mine.
So I shipped them back.
I went to the pick-A-part and got me some seats from an old RX-7. They were not a direct bolt-in. I had to mount an aluminum plate on the factory tracks, and then the seats onto the plates. The outboard sides of the RX were at a different height than the inboard, so i had to get creative. Very nice once mounted.Lots of support for a streeter, and very comfortable on day-trips. And just the right height headrests for the scale of the car. Tuff buggers too; I'm 210# now and they still support me. They were old when I put them in there in the early 2000s, and they still have no tears. I rate them AJ-approved!
Oh wait, I think the driver's seat is separating along the outboard edge of the back-bolster. But man, I think they were out of an early 80s model.