Where to degree my cam?
About to slide the cam in my LA 360 and am curious as to if I should advance or retard the cam, or just run it straight up.
The build is as follows:
'70 360 .060" overbore
SpeedPro H116CP pistons
Measured SCR of 9.3:1
Stock crank and rods
Cleaned up 587 heads with 1.88/1.60 valves
LD340 intake
340HP exhaust manifolds
833 4spd w/ 2.66 low gear
3.55FD
Sub 3000lb car
The cam I've selected is the CompCams 268AH-10 cam. I've attached a pic of the cam card.
Curious to as what you guys would do.