TELL ME WHY WE DO THIS?!!!!!
And to add more injury to that insult, after spending all afternoon trying to swap out tailshaft housing the bearing is larger bearing in the
E-body! WTF!
It's .4" larger than the B-body (one on the right that has the larger input bearing (one on the left) :eek:
And you might have noticed that a piece is broken off the housing on the left (the one I need) flange broke.
This happened because you have to move a snap ring out and out of the groove in the bearing than press then you can completely remove thr ring when the bearing is out . In the bearing in the B-body housing you can access this from both sides (see 2nd to last photo) but the other housing only has acess one side so I couldn't get it out so I tried while it was on the press and bang! Now I'm back to square 1:mad:
I not sure that will work, because the bearing is larger in as well. I'll give a look thanks.
And to add more injury to that insult, after spending all afternoon trying to swap out tailshaft housing the bearing is larger bearing in the
E-body! WTF!
It's .4" larger than the B-body (one on the right that has the larger input bearing (one on the left) :eek:
And you might have noticed that a piece is broken off the housing on the left (the one I need) flange broke.
This happened because you have to move a snap ring out and out of the groove in the bearing than press then you can completely remove thr ring when the bearing is out . In the bearing in the B-body housing you can access this from both sides (see 2nd to last photo) but the other housing only has acess one side so I couldn't get it out so I tried while it was on the press and bang! Now I'm back to square 1:mad: