Ignition switch wires identification
DDodger looking at it again I think you are correct. What's missing in my setup is the ballast resistor. The brown bypasses the resistor during "start", and once the ignition switch drops back to "run" the blue takes over. Since I'm not using a resistor if the brown and blue were tied together I'd get +12v during start and run. Brilliant! Thanks!
DDodger looking at it again I think you are correct. What's missing in my setup is the ballast resistor. The brown bypasses the resistor during "start", and once the ignition switch drops back to "run" the blue takes over. Since I'm not using a resistor if the brown and blue were tied together I'd get +12v during start and run. Brilliant! Thanks!
