Updates on the Demon Project
Been working on little things. Had to put front and rear glass on hold, windshield was toast, found after cleaning it up. I did get my new heater motor wired up because I used a shorter motor for the big block clearance, and doors together. Had to order inside handles but the locks all work as they should. Door jamb switches were a bear. They're the 1/2" instead of 3/8". Bought repro for drivers (3 pin). And one for chevy van for passenger. The chevy one is longer so I took it apart and shortened it to work, had to shorten the metal stem going thru and cut down the guide the button slides into and the spring. New windshield will be in tomorrow and hopefully I can get the man out to install them this week. I plan on getting car back on lift and going over everything underneath front to rear to make sure it's all good.
Been working on little things. Had to put front and rear glass on hold, windshield was toast, found after cleaning it up. I did get my new heater motor wired up because I used a shorter motor for the big block clearance, and doors together. Had to order inside handles but the locks all work as they should. Door jamb switches were a bear. They're the 1/2" instead of 3/8". Bought repro for drivers (3 pin). And one for chevy van for passenger. The chevy one is longer so I took it apart and shortened it to work, had to shorten the metal stem going thru and cut down the guide the button slides into and the spring. New windshield will be in tomorrow and hopefully I can get the man out to install them this week. I plan on getting car back on lift and going over everything underneath front to rear to make sure it's all good.
