Would these be acceptable

When I initially measured how far down in the bore the pistons were I installed assy but did not torque anything down cause Ive read that the rod bolts can only be stretched so many times before they become damaged.

Snugged down bolts/nuts, took my measurements and asked machinest to remove .013 off the odd side and .022 off the even side which he said he did, now Ive taken the same steps to reassemble ( just to check his work ) and these are the measurements Im getting.

Id say the even side is where he started, those measurements are pretty good, the odd side dosent look so good to me?

Would I be out of line to ask the guy to make it right?

Pistons went back in the same hole, no screwups there and everything was tightened the same way it was initially.

Safe to assume that the even side is acceptable? Hes working with very old equipment, I wasnt expecting absolute perfection but on the same token I want to get what I thought I was paying for which would have been everything close with .002 max.