SPC ADJ Control Arms

340 demon 72 said
I just ordered a set of these for my 72 DEMON so what you are both saying is remove 3/16 of an inch off of both ends of sleeve and an additional 3/16 off of each end of the threaded rods on the rear arm of the control arm. Ok I get that but that being said did you have to do both pass & driver sides also how about the fronts did you need longer ( or shorted) sleeves or were the standard 4 inch ones good ???????

I had to modify the hexagon part and the ends of the threaded rods because I have my car "jack up". You probably won't have to modify your parts if you keep the car stock or even a little higher than stock. The higher the front end the shorter the upper arms need to be. I'm pretty sure that you shouldn't have to modify anything if you keep your car at a stock height. Maybe someone will chime in.

treblig