8-3/4 fixture, for your engine stand!
above from left to right,7290 yok, holder for that yok. the chrome bar is off a snap-on 3/4 drive. I has a pin that hold the head on. I drilled a small hole in the holder so the ratchet bar snap into place.
adj and homemade too the a socket that i was going to have welled in place........found the proper tool online and bought it.
the only thing left to do is buy a 2nt set of bearings that i can modify to be "set up bearings.
Below is the pinion nut or yoke tool. if i need it later i can drill holes for a 7260 or 1350 yoke.
above from left to right,7290 yok, holder for that yok. the chrome bar is off a snap-on 3/4 drive. I has a pin that hold the head on. I drilled a small hole in the holder so the ratchet bar snap into place.
adj and homemade too the a socket that i was going to have welled in place........found the proper tool online and bought it.
the only thing left to do is buy a 2nt set of bearings that i can modify to be "set up bearings.
Below is the pinion nut or yoke tool. if i need it later i can drill holes for a 7260 or 1350 yoke.
