Can someone tell me where these go?

-
konrad

konrad

Active Member
Joined
May 10, 2013
Messages
30
Reaction score
3
Location
Iowa
IMG_0717.JPG
IMG_0716.JPG

Dumb of me not to pay attention to this, but removed engine and transmission and these came from somewhere. I'm starting to reassemble the car and need to know where these go. Thanks in advance.
 
Those are engine to trans braces/support brackets. 1 for each side....
 
and if your installing headers they are exactly where they need to be...OFF of the car
 
I have those exact same braces sitting in the garage. I was going to post a pic as well this weekend. Guess I dont need to now..
 
72B53FB7-AC1A-4C3F-9CD8-B35EAA772618.jpeg
This will complete this post. The brackets are unique between sides but just in case you are not near your small block to test fit them attached image is the drivers side bracket so you can tell them apart.
 
Hard to get a good picture of them installed. On my 67 Barracuda 273

Passenger Side:
2018-08-05_001.jpg


Driver Side:
2018-08-05_004.jpg


There seam to be a couple different styles, the previous post shows a style that is different than I posted above.
I'm not sure what years each style are for I have a few sets from 66-73, don't recall which ones came from which cars.


Alan
 
Cuda Al said:
Hard to get a good picture of them installed. On my 67 Barracuda 273

Passenger Side:
2018-08-05_001.jpg


Driver Side:
View attachment 1715207284

There seam to be a couple different styles, the previous post shows a style that is different than I posted above.
I'm not sure what years each style are for I have a few sets from 66-73, don't recall which ones came from which cars.


Alan
Click to expand...
The Two sets I have are from a ‘67 273 and ‘68 318 And they are both the same. They are both different leangths so you can’t mix them up.
 
They are used on a 4sp..... On the hydraulic clutch cylinder firewall mounting bolt to the shock tower!
 
You must log in or register to reply here.
-

Back
Top