New Batch of Bronze Brake and Clutch Bushings Ready to Ship

ValiantOne said
I don't know as I've never tried that. I think the needle bearings were used on the HD units. The HD units have a 1 inch bore diameter if I am not mistaken. I'll be curious what you measurements are. I have not made any of the HD bushings yet (brakes) but I do have the material for it.

The needle bearings are available, and I think I'd just use modern replacements if my assembly was set up for them. But I can always turn a set of bronze bushings to fit it as well.

CE
Click to expand...
Yes, my brake pivot shaft is 1.00 inch. I definitely want a set for the brake pedal when you make them. I can get replacement clutch pivot shaft needle bearings from brewers so I will use those. Just FYI, the clutch pedal pivot shaft was about 0.57 inches. Varied a little more or less depending where I measured it. Thanks.