Looking for Info / Specs on Obsolete Mopar Piston

That's why I said to deck the block and put the piston out of the hole. If the head is .080 recessed and you stick the flat out .050 that will give you .030 quench. A Fel-Pro 1008 is .039 so you'd be at .070 and if that's the case, you can mill another .030 of the head. Then machine the dome to get the desired compression ratio.

I'd have to do a bit of checking because I have that piston out in the shop but I think *I THINK* the rings are low enough you can stick the piston .060-.070 out of the hole if you have to.