Did I slip a tooth?

Cope said
I'm not at home now but I think I wired it right. I used the MSD diagram.

Also it will fire the coil when I spin the distributor. Spun by hand or spun by the drive gear it's firing the coil.

RE-read my post above. Is this a different distributor? Try reversing the pickup wires. Google "rotor phasing." You can do this with alligator clips temporarily

CHECK THE RELUCTOR is installed correctly!!!!!!!!!!!!!!!!!!

These are used in both big block B/RB (ccw) and SB (cw) rotation. You should have the correct rotational arrow next to your retainer pin in the reluctor slot

See the CCW arrow next to the roll pin on the right side of the photo? This is for a B/RB engine, a SB you need the OTHER pin slot