has anyone made a clutch for adjusting rod?
I know that you're looking for a quick fix (for now), sometimes you just have to make things work temporary. If this is a pic of your actual clutch push rod then I was wondering if it's actually aligned properly?? It looks like the clutch arm pivot point is further out than the other end (Z bar lever). It looks like it's misaligned and might be why your rod got bent/broken (damaged)??
Either way, good luck, I'm sure you'll figure out some way to fix it correctly.
Whenever I have a material failure I always try to make the new part more heavy duty than the last one,,,,but that's just me:steering:
Treblig
I know that you're looking for a quick fix (for now), sometimes you just have to make things work temporary. If this is a pic of your actual clutch push rod then I was wondering if it's actually aligned properly?? It looks like the clutch arm pivot point is further out than the other end (Z bar lever). It looks like it's misaligned and might be why your rod got bent/broken (damaged)??
Either way, good luck, I'm sure you'll figure out some way to fix it correctly.
Whenever I have a material failure I always try to make the new part more heavy duty than the last one,,,,but that's just me:steering:
Treblig