69 Dart door glass alignment...

RedFish said
The body lines don't look too bad ( waay to close at the bottom corner ). How do we know the body shop didn't work the quarter to a sagged door? Open the door a couple inches, grab that lower corner and lift. That'll show you wear in the lower hinge if its there. Lets hope the glass issue will adjust away regardless.
One of the stops is a eccentric block by the ring gear of the regulator. Hex head with a flat head slot in its center. I forget is that up or down stop. Other stop is 'L' shaped block mounted on the door with a single bolt in a slotted hole. Good luck with it.

I don't believe that the car had a sagging door when the quarter was hung. The car was only 2 months old when he crashed it.
I measured the height of the glass at the rear of the door with the window all the way up. The drivers side was 3/8" lower than the passenger side is. So the glass is the problem. It is not parallel to the weather stripping. So it seems that I will have to tilt the front track. to get the rear of the glass up. I did check the roller and it is still intact.
Does anyone know what this stud in the picture adjusts?