Finally, my first 360 and goals for it! I'll be asking a lot of questions.

trebor75 said
Change of plans! I ordered a set of Edelbrock RPM heads :) A lot of other things has started to come in recently too. Still waiting for the heads though. View attachment 1715090057

I followed RustyRatRod's cam bearing install thread. Thanks Rusty! Everything lined up nicely, but of course I f...d up on the last bearing. Will have to get a new one and try again. Slid my old cam in the 4 ones I managed to install and it turned around no problem with my hands and a little assembly lube.

View attachment 1715090058

I'm gonna continue this buil in my old project thread: 1970 Duster project in Sweden
Hope you follow it there!

Hey Dude, checked back in on this thread & wanted to comment....... in the 1st pics of the block, #6(bore#1 & crankpin) there is an area in the bore that appears to have
a circumferential crack or corrosion line, left in the pic...frt. of eng. side of the cyl bore. Optical illusion? Also, what is the new compression ratio target w/the Eddy heads?
There is going to be a difference in intake port from the matched teener ports, but should be fine.