Drainage holes in Subframe connectors

TrailBeast said
That's about it, but we do like to over think things here don't we.:D
My Brother and I built mine with .085 wall and they are welded to the back of the cross member right next to the torsion bar sockets and also extended on the under side of that cross member welded and also welded to the bottom of the front frame rails.
They ain't going anywhere and neither is anything they are welded to.:D

View attachment 1715090220

I actually ran across your design some time back which prompted me to look closer at mine. That's when I found water would sit in the tubing until I jacked the front end up so it would run out.

I really like how you fold that small section in and weld the tubes closed. Had I known awhile back I would have done the same. I'll save that tidbit for my next car.

Thank you!