Moser 3" Press In Wheel Studs 8020, .685" Knurl

I have run into this several times, but if you are measuring the old ones you took out the spline, knurl is smashed down a little. I have had to drill out the holes to get them to press in but I was further off than you, your only .020" difference.


Doesn't look like Moser offers a .665 3" stud only a short stud, same problem I was having, couldn't find the correct size. I ended up buying a metric drill bit that was the closest I could get and that worked. I did go through a couple sets of studs though.