Clunk noise on the 1/2 shift in an A999 trans.

So here is what I did with the bands. The front band (accessible from outside the case) was snugged up to 72in/lbs then loosened off 2 turns, the rear band (accessible from inside the pan area) was snugged up to 72 in/lbs then loosened off 4 turns. Am I right so far? I will loosen off the front band by 1/2 turns and see if that helps now that everything else is right with the world if none of these other things turn out to be the issue.

I will double check my trans mount because I did screw with it a bit when the trans was out but I thought it was good. Motor mounts are good for sure. I will put the weight back on the back just incase too.

The diff has a bit of a clunk but not too bad at all compared to other old Dodge trucks I have run over the years.

Thanks for the comments guys, I will get back to this on Friday.

Cley