360/727 cooler lines.
I'm pretty sure I know the answer here, but here it goes. I'm finally getting around to putting the motor in my 70 dart. It's a Magnum 360 and a 727 using the transdapt /6 to small block mounts. I attempted to install my new SS cooler lines that I picked up from summit. Neither of them fit great, but I've dealt with pre bent fuel, brake, and trans lines on a camaro I had and now this dart. They ALWAYS require some tweaking. No amount of "tweaking" will fix this.
They are both threaded onto the transmission and routed as correct as I can tell. The line the ends in the engine bay seems to be correct and I can make that work. But the other line would stick out well past the bumper! Anybody had this issue? I'm assuming it's just a case of incorrectly boxed parts. It's been 3-4 months since I ordered them do hopefully summit can do something about it.
I'm pretty sure I know the answer here, but here it goes. I'm finally getting around to putting the motor in my 70 dart. It's a Magnum 360 and a 727 using the transdapt /6 to small block mounts. I attempted to install my new SS cooler lines that I picked up from summit. Neither of them fit great, but I've dealt with pre bent fuel, brake, and trans lines on a camaro I had and now this dart. They ALWAYS require some tweaking. No amount of "tweaking" will fix this.
They are both threaded onto the transmission and routed as correct as I can tell. The line the ends in the engine bay seems to be correct and I can make that work. But the other line would stick out well past the bumper! Anybody had this issue? I'm assuming it's just a case of incorrectly boxed parts. It's been 3-4 months since I ordered them do hopefully summit can do something about it.
