Thanks guys. Going in to work tonight so tomorrow i will test coil +ve with everything hooked up. Hopefully temps drop a bit so cooler and easier to work on. Ill try n test before work. I will clean both sides of dist leads and recheck. (and crimp them closed a little)
I may have to bite the bullet and pull distributor.
No to analog ohm meter. Cant I put digital one on "continuity" beep. And connect each probe to distributor leads (dist side) and it should beep while with cranking? Nope.
Voltage should fluctuate around 1 volt when testing for AC volts while cranking, but testing continuity will only show a steady reading.
Not sure if I have a spare distributor to swap in.
Ebay has a starter relay for $10. I may order for a spare.
Thanks again guys.
