Offenhauser 5615 intake
@Swingn'71
I hope these drivers side front to rear images aren’t to overwhelming. I have reduced it 3 times to the smallst I can. I pictured stock bolts for further reference. You can see I left the end of the area high up. This is how much material was removed from the bolt head pad on the Edelbrock. I do not know how the Weiand is cast/set up. But it would take this amount or so to adjust the angle of the intake to the later “LA’ head bolt angle. Some guys, (I wonder if they actually do this stuff….) suggested or said they cut there own aluminum wedges to adjust the bolt head. Sorry, I don’t get it.
Middle, back, front w/bolts and then without.
@Swingn'71
I hope these drivers side front to rear images aren’t to overwhelming. I have reduced it 3 times to the smallst I can. I pictured stock bolts for further reference. You can see I left the end of the area high up. This is how much material was removed from the bolt head pad on the Edelbrock. I do not know how the Weiand is cast/set up. But it would take this amount or so to adjust the angle of the intake to the later “LA’ head bolt angle. Some guys, (I wonder if they actually do this stuff….) suggested or said they cut there own aluminum wedges to adjust the bolt head. Sorry, I don’t get it.
Middle, back, front w/bolts and then without.
