408 Stroker

RAMM said
Listen to crackedback,AJ/FormS and Moper if he has chimed in. I like to over-engineer so commenting from experience I would go against the grain and build a solid 380-400 hp STOCK stroke 360. Stick some Speed-pro flat tops H116CP pistons on stock rods with ARP bolts or Scat I-beams-balance and use a Lunati Voodoo 10200703 cam with stock rockers. I have made close to 430 HP/440 tq (365) with this and J heads (1.94/1.6 231 cfm @ .450") There you go, save your money say no to 4" strokes. J.Rob

Those are very impressive numbers. This sounds incredibly affordable. I already have a Air Gap intake and 1 5/8 Doug’s long tubes. My heads actually only have the 1.88/1.60 valves with stock non adjust rockers. In your opinion I should probably look for a set of heads? As far as bore goes maybe 30 over to make the hole round again? Anything I should do to the block? Thanks for this info.