SRT8CUDA Build
Making progress. Found that the slave cylinder was leaking some fluid plus the spring that pulls the clutch fork rod back was too weak. Removed and disassembled the slave and found that the o-ring that seals the piston rod shaft had been assembled incorrectly into the groove in the end of the piston. It wasn't fully seated in the groove!!! Will have to see if I can get a seal kit from CNC.
View attachment 1715112260
Making progress. Found that the slave cylinder was leaking some fluid plus the spring that pulls the clutch fork rod back was too weak. Removed and disassembled the slave and found that the o-ring that seals the piston rod shaft had been assembled incorrectly into the groove in the end of the piston. It wasn't fully seated in the groove!!! Will have to see if I can get a seal kit from CNC.
View attachment 1715112260
