Deathtrap, My 74 Plymouth Scamp
I had a slight problem with brakes sticking but I posted over on the brakes section and got some info. Seems my brake booster rod was adjusted wrong and not letting pressure off. So I got that adjusted up better and I've had no problems with it. Pulled it in to the shop yesterday and did an oil change sense i wasn't sure when it was done last. Also started to weld up some holes in the engine bay, I will body work it later when the engines out but it looks a little better now! When I removed my heater I never sealed up the fresh air intake, so I busted out the plasma cutter and got a piece cut. When I went to put it in i found a lot more surface rust. So it's time to bust out the wire wheel and get to Work! Figure I can get it all cleaned up nice shoot some paint and then put new seam sealer on it. Also I made a sheet to cover where my old heater controls went. I think it cleans up the look and makes it more clean. I will continue making a couple more panels for my glove box and where my radio is. Once that's all done I will get a new fuse panel and relay block mounted up and hide all the wiring behind the dash in a nice loom.
I had a slight problem with brakes sticking but I posted over on the brakes section and got some info. Seems my brake booster rod was adjusted wrong and not letting pressure off. So I got that adjusted up better and I've had no problems with it. Pulled it in to the shop yesterday and did an oil change sense i wasn't sure when it was done last. Also started to weld up some holes in the engine bay, I will body work it later when the engines out but it looks a little better now! When I removed my heater I never sealed up the fresh air intake, so I busted out the plasma cutter and got a piece cut. When I went to put it in i found a lot more surface rust. So it's time to bust out the wire wheel and get to Work! Figure I can get it all cleaned up nice shoot some paint and then put new seam sealer on it. Also I made a sheet to cover where my old heater controls went. I think it cleans up the look and makes it more clean. I will continue making a couple more panels for my glove box and where my radio is. Once that's all done I will get a new fuse panel and relay block mounted up and hide all the wiring behind the dash in a nice loom.
