How do I remove center bezel on my 71?

@RedFish is correct. I just wanted to add if either of those screws are broken do not worry, it's actually a poor design from Chrysler, they often break. A lot of stress are put on those screws from the heater/vent control levers as well as holding on the center bezel. They are also a main source of rattles - they loosen easily and will cause the heat/vent control to rattle. Additionally you can't make them very tight as they screw directly into the boss on the bezel (they often crack the bosses). Inspect carefully when you remove it.

If you run into cracks or broken screws don't worry, you can still use the center bezel. Simple cut/grind off the 2 bosses on the back of the center bezel. Use 2 small bolts/nuts (or even 2 zip ties anchored securely) to hold the heater/vent controls directly to the dash. Then put the center bezel over it. The center bezel will be held in place by the 2 screws on top and the 2 radio knobs. Problem solved, still looks stock, and no more rattles.