TTI 2.5" Exhaust system install....many problems

Almost done. I say almost because I ran into yet another problem. Now the shift linkage is hitting the exhaust so I cant get it in drive. A very small ding would give it clearance but its going to be tough to get to the spot. I also had to re-route the starter cable. Might have been fine if I was running a mini starter.
I used a PH8A filter with the 90° adapter. It has just enough clearance to change the filter.
I need a spring on the heat riser shaft, it rattles terrible. I never noticed before because of all the exhaust leaks. The engine compartment is so quiet that the noisy pcv valve is driving me crazy.

I also left it with turn downs for now. I have a plan to install the tips and it should be fairly easy. I do need to address some rust on the side of the frame where the tip hanger mounts......another day.