Quicktime SFI approved bellhousing behind 400 stroker ( A833 trans )
I would mock everything up before it goes in the car. This is another good reason to install the engine, trans and front suspension by lifting the car and installing everything from the bottom like the factory did.
I had to grind 2 notches in the flange of my Lakewood scattershield to clear the header tubes as they passed the bell housing. It would have been easier to do out of the car.
Also make sure your both square and center the bellhousing to the motor.
I would mock everything up before it goes in the car. This is another good reason to install the engine, trans and front suspension by lifting the car and installing everything from the bottom like the factory did.
I had to grind 2 notches in the flange of my Lakewood scattershield to clear the header tubes as they passed the bell housing. It would have been easier to do out of the car.
Also make sure your both square and center the bellhousing to the motor.