Lets spec out a roller cam for my LA 318

adjustable valve gear could be needed if cam is
reground a lot? I have 2 of these 318 roller motors
currently running. 1 of them I sent the factory cam to Delta Cams specs: 205/208 .450/.470 110 cl installed 4 deg advanced (automatic car) has loads of torque, idles 18in revs very good to over 5K.
The other has a Hughes 208/214 .480/.490 114 cl installed straight up (4 spd)seems
a little softer on low end but comes on stronger above 3k, idles about 17in this was a reground from Hughes seemed to have lifter pump up issues when cold, I installed 273 adjustables seems to have eliminated cold noise for the most part. Thinking about Rhodes roller lifters
to improve low end. Would recommend either in
your case, I would either degee cam CL or advance cam. You can also look at Magnum cams and get a snout extender from Hughes (using on Hughes OK) Before choosing do a compression test to get an idea of what size cam to use (thin head gaskets) if low. I run
87 octane fine.