Jackstand on both sides, to the front of where the rear springs are attached. It is part of the Uni body, and more or less flat. Tough to explain, I will try to get a picture if you need.
Thanks! That makes sense as this is a load bearing point on the chassis anyway. When I was on the creeper spraying the bolts with the penetrating oil, I though that looked like the proper spot but I know better than to just guess when it comes to supporting the weight of the car. :D
Ha! Will do. While I planned to (seemed like a good idea to remove ~110lbs of weight from the assembly before unbolting it! ) I gladly accept any advice, no matter how obvious.