Lean burn to old style ign swap?

BigBlockMopar28 said

Why the gm module? Also, not sure what i'm getting myself into as far as using plugs that mine doesn't have (ex the connector for the mopar module if i was to go that route), and what sensors that the current brainbox uses that would be used/discarded. Never messed with this stuff so any basic tips and such are greatly appreciated

Click to expand...

The GM wiring is actually simpler than the Mopar. You don't need a resistor, and you can actually use the stock Mopar coil. Just wire it up as per the diagram, pay attention to the connection polarity at the distributor. Make sure to mount the module on a flat area for heat sink, AKA a scrap piece of aluminum plate, etc. There's a plastic "tit" you'll have to break off the bottom. Only connector you'll need is to mate the the new distributor, and you could cut one off the old lean burn dist or your harness