Post your Super Stock clones

I had to cut the hell out of the new TTI exhaust to make it work. The right side tail pipe was cut down about 3" to make it clear the gas tank strap and the frame rail. Since the 67 gas tank strap goes left to right not front to back it would of never cleared. Since the headers had to be made to fit the heads and the body I had to add to the front pipe to make it wider and shorten the right side and cut the ends off so I could put the chrome tips. Them like I hadn't put enough into the exhaust I had the whole system Jet Hot coated. The tips were also cut down and opened up to fit over the 3" pipes and the factory hanger bracket was cut off and tig welded up, then I had them rechromed. Plus had to add the openings for the dual exhaust 67 had the flat rear valance panel. I think the only way it worked is the 8.75 rear axle, but when I put a stick in it I may put a Dana just for the look.