How to install rocker studs included with edelbrock aluminum rpm head?
Thank you everyone for the input. I think I now understand how everything goes together. The edelbrock heads I’m installing are actually part # 60829 which is BB mopar performer RPM heads with 75cc chambers. I can’t wait to get everything back together. I have added another pic that I looked up when attempting installation. If you look at the diagram it clearly shows that on two the rocker pedestals it is marked with an S. That is where the rocker studs go in. The problem was I didn’t know how everything works together. Especially the thin round spacers. I’m putting my Harland sharps from my 915 heads on. Also I had a trusted machine shop go over everything and do some mild porting. The heads were decked slightly to be true and gone through and they are ready to rock. I’m just still a little unsure of how to fit the spacers. Thanks again.
Thank you everyone for the input. I think I now understand how everything goes together. The edelbrock heads I’m installing are actually part # 60829 which is BB mopar performer RPM heads with 75cc chambers. I can’t wait to get everything back together. I have added another pic that I looked up when attempting installation. If you look at the diagram it clearly shows that on two the rocker pedestals it is marked with an S. That is where the rocker studs go in. The problem was I didn’t know how everything works together. Especially the thin round spacers. I’m putting my Harland sharps from my 915 heads on. Also I had a trusted machine shop go over everything and do some mild porting. The heads were decked slightly to be true and gone through and they are ready to rock. I’m just still a little unsure of how to fit the spacers. Thanks again.
