My 72 Demon

If you dont remember this is the personal message you sent me after you saw a picture of my car in another stripe unrelated thread.

“Just thought I would let you know that your stripes were installed to low on your car. I see this done on many Demons because the fuel cap cut out is not in the stripe as the OEM styles were. Check out these original paint Demons The gas cap stripe portion was painted on from the factory. This brings the stripe up off of the wheel well and shows more color above the wheel.
The stripe does not sit centered on the body line. The body line is on the top of the bottom stripe in the rear and on the bottom of the top stripe in the front. How I know this is I installed many of them when they were new.
I am in no way putting your car down it is a beauty. Just some info you may want for the future. Some mopar enthusiasts may point this out to you. and they will be correct
I look at alot of Demons and many are put on just like yours. Guys put the stripe on under the handle on the fuel cap and cut it out. Asstated the fuel opening was in the stripes when bought from Mopar OEM. The stripe could only go on at the correct height.”

And heres my reply

“you think all of them were installed the same from the factory? I gurantee that some were installed lower and higher, they were installed there because i think it looks best with relation to the body line, and from what i gathered off this site it seems that the stripes varied upon the location of install. I know you mean well but a little ways to go out of your way to tell me something i already know lol
To me it looks stupid with the stripe partially on the body line, you can see part of the body line from the side view as the light transitions”

I stated i know for 100% the factory placement was never exactly the same, i also stated i already knew they werent in the factory spot and they were installed where me and my dad thought looked best. Im tired of repeating it