360 build thread

snailpower said
I ran into that a few months back with the same pickup and tube. I was using factory bolts though not studs. I tried welding a stud onto one of the bolts which was a no go, so I did what I should have from the start and called up kevko. He had the correct mopar bolt with a stud on the end for around $17. Might give them a call and they should have something for you cheap.

I think I remember that thread, at this point I'm not trying to not use the main studs since the caps were lined bored with them and the bearing clearances were taken with the current setup, not sure how much it would change but I'm running tighter tolerances so I don't want to mess with it too much.