what solid cam is equivalent to a hyd 268 ?

stroker402 said
found this article on our site about oil pumps . I bet I was sucking the oil pan dry because this engine took so long to rev up.>>> High pressure requires a stronger intermediate shaft (and sometimes a drive gear change)
High volume can starve the engine for oil at higher RPM's due to pulling the sump dry before the oil can get back down into the pan again.
A standard pump can have not enough flow and pressure for a loose engine.

For a regular performance street motor a standard pump is totally fine.

Two things.

You didn't suck the pan dry. That is total bullshit.

Two, why are you married to the idea you either have to run that goofy cam you have, or an E4 Isky? I've been doing this **** for DECADES and I still don't understand why guys won't pick up the phone and order a cam that is custom for your application. Frankly, it's just stupid no to. For what you are doing call somebody not named Comp and get a cam.

Your **** will run better and you will be happier in the end.