Building a hot 360

For a short block rebuild, I love ether the KB-107 or the Speed Pro 116 hyper slugs. At a zero deck height with a .038 head gasket, there approx. 9.8-1 in a 70cc J head. If the piston doesn't sit at zero deck, which it probably will not, you'll be in good shape. I ran this 360 combo (same as yours above) on 93 octane and a Purple 292/.509 cam. No problems.
Car was a '73 Cuda, 4spd, 4.10's, 28 inch tire.
If you get this well tuned, you should be able to run low 12's. Better if your a light weight car.


With me in it, it’s 3560 and the your saying have the block zero decked with the kB postions?
What kinda can would you recommed?

My engine is going together here soon with the same goals.

360 .30 over
Speed pro flat tops and edelbrock heads
10:1
Hydraulic roller cam that is .522 lift
Performer rpm intake and 750 dp
Tti long tubes.

Dyno day should be in a couple weeks so I will try to remember to post my results on this thread for you.


Really wish I could go roller but not in the budget.