How hard is it to change a starter in a 340 Duster?

I' with YR on this. In my car its about the hardest job you can ask for.
Step 1. Drain coolant.
2. Unbolt Driver side motor mount.
3. Unbolt Driver side header.
4. Raise engine.
5 fight the headder off the studs.
6 unbolt the Adel clamps that keep the starter hot wire off the header.
7. Unbolt starter, roll starter over so I can reach the wires and remove.

Oh yeah my car is a race car so it has a battery disconnet but don't forget to remove the hot wire off the battery before you weld the ratchet to the exhaust.... also raise the car and Jack stand the front so you can even get under the car....

Almost forgot, I also pull the pin on the steering box and slide the shaft up into the car for more room. I don't have a collum so it'
Just the one pin and It out of my way.

It sucks bad....