Heres mine. I got the metal as scrap per lb, I think it was 2 @ $10 bucks. Front was an endplate and a birdshit flux core weld. Its ID was same as OD of rear subframe so it slipped over rear frame rail. Pin it with a through-bolt and weld it up. Just make sure your frame is up on LEVEL jackstands and your doors shut properly prior to welding, as you may weld in a body sag that will make your door clearance close up. I tacked it a few places where I could to the pan but it was just a few places. Dont know why the flash blew out the welds but you can see them for sure! Wire brush the slag/rust afterwords and hit with any paint as it will flash rust.
View attachment 1715158749 View attachment 1715158750 View attachment 1715158751
